KILZ® ORIGINAL Aerosol Interior Primer
KILZ® ORIGINAL Oil-Based Primer is a powerful stain blocking formula that blocks most heavy interior stains including water, smoke, tannin, ink, pencil, felt marker, grease, as well as sealing pet, smoke and otherunwanted odours on the surface prior topainting.
This convenient aerosol is ideal for small paint projects and spot priming interior surfaces including wood, drywall, plaster, paneling, wallpaper, masonry, brick, painted metal and properly prepared glossy surfaces†. Not recommended for mold or mildew-prone surfaces or flooring.
Promotes Adhesion
Helps Block/Seal Odors
Hides Previous Color
Helps Block Heavy/Severe Stains
- The surface must be clean, free of dust, grease, wax, peeling paint, mold, mildew, and/or wallpaper paste. If washing is necessary, use a non-soapy detergent or a TSP substitute. Rinse well and allow to dry.
- Peeling or Checked Paint: Scrape off loose paint and sand to a smooth surface. Sanding or removal of paint containing lead is hazardous.*
- †Glossy Surfaces: For maximum adhesion, scuff sand the surface thoroughly before priming.*
*WARNING! If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. Contact the National Lead Information Center at 1-800-424-LEAD or log on to www.epa.gov/lead.
Application
- Eye protection is recommended.
- For best results, use at room temperature. Cover adjacent areas to protect from overspray.
- Shake can vigorously for 1 minute after mixing ball begins to rattle and often during use. Hold can upright, moving from side-to-side while spraying lightly and evenly about 30cm from area being painted. 2-3 thin coats produce best results.
- Topcoat with latex or oil-based paint after 60 minutes. NOTE: On some surfaces, spot priming may cause a non-uniform appearance in the final coat. To avoid this, prime the entire surface.
Read More
Dry Time at 77°F (25°C), 50% RH
- To Recoat / Topcoat: 1 Hour
- Longer dry time may be required in cooler temperatures and in higher humidity.
Read More
Clean-Up & Disposal
- Clear spray valve immediately after use by turning can upside down and spraying until only clear gas is released. If spray nozzle becomes clogged, remove and clean.
- Do not stick pins or wire into can opening.
- Clean fresh overspray with mineral spirits or paint thinner. Remove dried paint with paint remover, but test small area first to ensure paint remover does not damage substrate.
- Please consider donating any unused product. For recycling or disposal information contact your local household refuse collection service.
Read More
Read More
PRODUCT SPECIFICATIONS
Base
Oil
Int/Ext
Int
Colour
White
Coverage
1.9 m²
Finish @ 85°
<10
Min Application Temp
2°C
Max Application Temp
32°C
Dry To Touch
15 - 30 min
Dry To Recoat
1 hour
Max VOC (by weight)
60%
Max Product Weighted MIR
1.2
Volume Solids
18.0% (+/-) 2%
Weight Solids
40.0% (+/-) 2%
Flashpoint
-156°F (-104°C)
