KILZ Upshot® Aerosol
Interior Primer
KILZ® UPSHOT® is a convenient easy to use vertical primer spray to hide and block most stains on ceilings and overhead surfaces. It can block stains caused by water, smoke, tannin, grease, nicotine and seals odours. Come with a wide comfort vertical spray tip. Use on interior surfaces including wood, drywall, plaster, paneling, wallpaper, masonry, brick, painted metal and properly prepared glossy surfaces.
Seals Porous Surface
Promotes Adhesion
Helps Block/Seal Odors
Hides Previous Color
Helps Block Heavy/Severe Stains
KEY FEATURES
Oil-Based. Hides and blocks stains on ceilings including dried water stains. Excellent adhesion to multiple interior surfaces and particularly for drywall ceilings, accoustic ceiling tiles and wood. Comes with a convenient vertical spray tip equipped with wide integrated comfort tip. Fast drying, Sands easily, Odour blocking, High hiding, Seals porous surfaces.
BEST FOR USE ON
Interior overhead surfaces and ceilings. Apply when spot priming, touch-ups and spray priming for wood, drywall, plaster, gypsum, paneling, hardboard, cement board. May also be used on brick, masonry, concrete, cinder block, fiber cement, galvanized and non-ferrous metals, chalky and glossy surfaces.
Coverage
1.3 m² - 1.7 m²/Can
TECHNICAL DOCUMENTS
- The surface must be clean, free of dust, grease, wax, peeling paint, mold, mildew and wallpaper paste. If washing is necessary, use a non-soapy detergent or a TSP substitute. Rinse well and allow to dry.
- Peeling or Checked Paint: Scrape off loose paint and sand to a smooth surface. Sanding or removal of paint containing lead is hazardous.*
- †Glossy Surfaces: For maximum adhesion, scuff sand the surface thoroughly before priming.*
*WARNING! If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. Contact the National Lead Information Center at 1-800-424-LEAD or log on to www.epa.gov/lead.
Application
- Eye protection is recommended.
- For best results, use at room temperature. Cover adjacent areas to protect from overspray.
- Shake can vigorously for 1 minute after mixing ball begins to rattle and often during use. Hold can upright, moving from side-to-side while spraying lightly and evenly about 30cm from area being painted. 2-3 thin coats produce best results.
- NOTE: On some surfaces, spot priming may cause a non-uniform appearance in the final coat. To avoid this, prime the entire surface.
Read More
Dry Time at 77°F (25°C), 50% RH
- Topcoat with water-based or oil-based paint after 1 hour
Read More
Clean Up & Disposal
- Clear spray valve immediately after use by turning can upside down and spraying until only clear gas is released. If spray nozzle becomes clogged, remove and clean. Do not stick pins or wire into can opening.
- Replace nozzle with valve opening pointed away from you. Clean fresh overspray with mineral spirits or paint thinner. Remove dried paint with paint remover, but test small area first to ensure paint remover does not damage substrate.
- Please consider donating any unused product. For recycling or disposal information contact your local household refuse collection service.
Read More
Read More
